Subject: Cutting P Port
From: Rotary Engine
Date: 3/26/2007, 11:07 PM
To: AARotary Engine

      I don't think that will work as the tube end is not square
      nore is the rottor housing surface.
      Friction welding works by spinning the parts up and jaming
      them togehter.


      Paul Lamar ...No rotor no motor.


  They are using friction (stir) welding to replace riveting in the
  assembly of parts of the wings on Eclipse jets.


  Matt-

Matt, I believe friction stir welding requires a more flexible substrate. (like aluminum sheet for a fuselage) I don't believe it will work on a pat as thick as the housing, but I'm not totally up on the process.

Paul, A socketed tube can be friction welded but you would have several clean up operations afterwards.  The tube would have to protrude into the chamber, and it would need to be trimmed off. The intersection could have a small taper, (which might even be an advantage),  to get the entire active surface to hit at once. There might be too much torque applied to the steel portion warping it, but the heat from friction welding is very contained to the area. Might not be worth it when JB weld can work just fine.
Bill Jepson

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.