Subject: Damper plate torquing conundrum
From: Rotary Engine
Date: 3/26/2007, 11:05 PM
To: AARotary Engine


  While reinstalling the engine into my M2 today I ran into a puzzler -
  hopefully someone has an obvious solution I'm overlooking.

  I can't figure out a way to torque the damper plate bolts to the proper
  settings with the engine installed in place. There is not room for the
  torque wrench to squeeze in between the redrive mount and the damper
  plate itself. I am using a pretty hefty 1/2" drive torque wrench, so
  maybe I just need to try to find a more delicate one. But the primary
  probem is the depth of the torque wrench + the length of a 5/8" socket
  is just too much.

  Any clever ideas or exotic tools I don't know about?

  Mark Supinski
  -------------------------------------------------------------

  Mark,  3/8" and 1/4" torque wrenches have lower profiles and may be
  able to torque your bolt.    If all else fails, torque is simply the
  length of the wrench times the tangential force applied.  A box end
  wrench on the bolt and a fish scale pulling on the other end at a
  right angle to the wrench will measure the torque.  Example a 9 inch
  wrench (.75 ft) and a 60 pound pull on the scale will have a 45
  ft-lb torque. (.75 ft x 60 lb = 45 lb-ft)

  Joel


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.