Subject: Damper plate torquing conundrum
From: Rotary Engine
Date: 3/26/2007, 11:06 PM
To: AARotary Engine


  While reinstalling the engine into my M2 today I ran into a puzzler -
  hopefully someone has an obvious solution I'm overlooking.

  I can't figure out a way to torque the damper plate bolts to the proper
  settings with the engine installed in place.  There is not room for the
  torque wrench to squeeze in between the redrive mount and the damper
  plate itself.  I am using a pretty hefty 1/2" drive torque wrench, so
  maybe I just need to try to find a more delicate one.  But the primary
  probem is the depth of the torque wrench + the length of a 5/8" socket
  is just too much.

  Any clever ideas or exotic tools I don't know about?

  Mark Supinski

Mark,
Several tools, notably a 12 point box end wrench offset with a 3/8 or 1/2" drive. I believe they were originally made for this exact purpose. The snap-on one even came with a chart with the multiplier to set your wrench by.
Bill Jepson

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.