Subject: Damper plate torquing conundrum
From: Rotary Engine
Date: 3/26/2007, 11:09 PM
To: AARotary Engine


While reinstalling the engine into my M2 today I ran into a puzzler - hopefully someone has an obvious solution I'm overlooking.

I can't figure out a way to torque the damper plate bolts to the proper settings with the engine installed in place.  There is not room for the torque wrench to squeeze in between the redrive mount and the damper plate itself.  I am using a pretty hefty 1/2" drive torque wrench, so maybe I just need to try to find a more delicate one.  But the primary probem is the depth of the torque wrench + the length of a 5/8" socket is just too much.

Any clever ideas or exotic tools I don't know about?

Mark Supinski
---------------------------

Mark,

I think it's called a box wrench (or open-end) and a calibrated arm.  Not
exotic, but should work just fine for that case.  You know, if  its a 12"
wrench, and you want 40 ft-lbs, you push/pull 40 lbs; if you're pushing on
the wrench 8" from the bolt you push 12/8 X 40 = 60 lbs. 
Whatever works,

Al

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.