Has anybody tried, or can you try, tig welding SS to a chrome bumper?
-- Paul Lamar ...No rotor no motor.
How about brazing the tube in? The brazing does not require very high
temps? After all it is the cool side of the housing.
Bulent
That might work very well. Good idea Bulent.
Does braze stick to SS? If not the tubes could be 4130
or other seamless steel tubing.
--
Paul Lamar ...No rotor no motor.
Hi Paul/Buly;
If you thinking of brazing, you might look at something like HTS-2000
aluminum to aluminum
brazing rods or something similar:
http://www.aluminumrepair.com/
I considered it - well done it would probably be far superior to epoxy.
It works quite well.
This would give far more surface area to braze an aluminum tube to the
aluminum housing.
It would likely require heating the housing on a bbq plus some welding
heat source due to thermal mass.
Worth a try...
Cheers
Cary
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.