Subject: tig welding to chrome
From: Rotary Engine
Date: 3/26/2007, 1:52 AM
To: AARotary Engine


    >>> Has anybody tried, or can you try, tig welding SS to a chrome
    >>> bumper?
    >>> -- Paul Lamar ...No rotor no motor.
    >
    > How about brazing the tube in? The brazing does not require very high
    > temps? After all it is the cool side of the housing.
    > Bulent
    >
    > That might work very well. Good idea Bulent.
    > Does braze stick to SS? If not the tubes could be 4130
    > or other seamless steel tubing.
    > --
    > Paul Lamar ...No rotor no motor.

   I'll ask the welder in the morning.
   Bulent
   -----------------------------------------------------------------

   SS is readily brazed using high or low temperature brazes or
   solders.  Pure copper can be used as a brazing material at 2050 -
   2100 F with a hydrogen atmosphere without a flux.  Silver and silver
   alloys used for brazing are  used at a much lower temp but usually
   require a flux.  Brazed surfaces must be very clean for a good
   braze.  Joint gap thicknesses of 0.001" - 0.003 " are optimum for
   high strength.  An acetylene flame can be used for the heat source.

   Joel
   Over the Hill Materials Engr.

I don't think we want to hit the inside of the rotor housing
with an acetylene flame.

Paul Lamar

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.