Subject: tig welding to chrome
From: Rotary Engine
Date: 3/26/2007, 12:19 PM
To: AARotary Engine

Has anybody tried, or can you try, tig welding SS to a chrome  bumper?
--  Paul Lamar ...No rotor no motor.
How about brazing the tube in? The brazing does not require very high
temps?  After all it is the cool side of the housing.
Bulent
That might work very well. Good idea Bulent.
Does braze stick to SS? If not the tubes could be 4130
or other seamless steel tubing.
-- 
Paul Lamar ...No rotor no motor.

"Brazing" is actually a common misnomer inasmuch as it is
temperature based. We commonly use it in reference to brass
or bronze welding due to the similarity in verbiage.
Technically, even aluminum can be "brazed".
Now that the definition has been somewhat clarified,
yes, ss can be "brazed", but requires some elevated heat, and
lots of flux. Silver solder can also be used.

Archie

This might be as easy as doing copper water plumbing
in your house.

Paul Lamar

Be careful.  I researched silver solder and related brazing  techniques for the oil pick up and learned that  brazes such as  silver solder that can be applied by a torch will break down over  time in sustained  temperatures around 300 degrees.  The operative  phrase is "applied with a torch" as there are brazes used inside  turbines or similar applications that are furnace brazed is special  atmospheres. Lot of information on brazing on the net.   Jerry



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.