Subject: tig welding to chrome
From: Rotary Engine
Date: 3/26/2007, 12:23 PM
To: AARotary Engine

    SS is readily brazed using high or low temperature brazes or
    solders.  Pure copper can be used as a brazing material at 2050 -
    2100 F with a hydrogen atmosphere without a flux.  Silver and silver
    alloys used for brazing are  used at a much lower temp but usually
    require a flux.  Brazed surfaces must be very clean for a good
    braze.  Joint gap thicknesses of 0.001" - 0.003 " are optimum for
    high strength.  An acetylene flame can be used for the heat source.

    Joel
    Over the Hill Materials Engr.


I don't think we want to hit the inside of the rotor housing
with an acetylene flame.

Paul Lamar


Hi Joel,
Perhaps you meant with a 'nitrogen' atmosphere?

Rolf


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.