Has anybody tried, or can you try, tig welding SS to a chrome bumper?
-- Paul Lamar ...No rotor no motor.
How about brazing the tube in? The brazing does not require very high
temps? After all it is the cool side of the housing.
Bulent
That might work very well. Good idea Bulent.
Does braze stick to SS? If not the tubes could be 4130
or other seamless steel tubing.
--
Paul Lamar ...No rotor no motor.
I'll ask the welder in the morning.
Bulent
Paul,
Melting point of Al about 660 deg. C
silver solder about 593 deg C
brazing alloy about 645 deg C
Would appear to be tricky to braze, silver solder or weld.
Colin Smith
The thing about tig is local heating is all that is required
while brazing or soldering wide spread heating is required.
Paul Lamar
I would recommend heat treating the AL after welding. According to the chart
the temperature for 6061 is only 375 F and then heat soaking the part in 70
to 90 F still air for 18 hours. (This heat treatment from "Performance
Welding Handbook, 2nd Ed." by Richard Finch pp. 109,110. The 375 F seems low
to me. I wonder if he means 375C? 375C is 675F. I could not find any contact
info in his book.)
If the 375F is correct, you could commandeer the kitchen oven. :)
The above assumes we can discover the alloy Mazda uses, and the heat
treatment, if any.
Doc Custer
Retired Software Engineer and sometime Audiologist
The aluminum is not going to get that hot if
we weld the SS tube to the steel liner. Also one
can skip weld. Weld four spots at 0 90 180 and 270
and let cool. Then weld the rest. We don't need to weld
to the aluminum at all. JB weld will handle the rest of
it.
I suspect that is better than heating the whole
works and trying to solder or braze.
This is just an experiment anyway. Not necessary for making p-ports.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.