Subject: tig welding to chrome
From: Rotary Engine
Date: 3/26/2007, 12:47 PM
To: AARotary Engine

Be careful. I researched silver solder and related brazing

techniques for the oil pick up and learned that  brazes such as  silver solder that can be applied by a torch will break down over  time in sustained  temperatures around 300 degrees.  The operative  phrase is "applied with a torch" as there are brazes used inside  turbines or similar applications that are furnace brazed is special  atmospheres. Lot of information on brazing on the net.   Jerry


Jerry, but the water jacked is only at around 200F withmaybe momentary excursions to 160.
Also you have the constant cooling of the intake charge. Sometime I see my intake pipes beading with condensation on the outside. Does not look like the heat would be a problem?
Bulent

Just remember guys this is just and experiment and
not necessary to build a p-port. JB Weld works
fine if done right.

Paul Lamar

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.