Subject: tig welding to chrome
From: Rotary Engine
Date: 3/26/2007, 4:10 PM
To: AARotary Engine



    > Be careful. I researched silver solder and related brazing

    > techniques for the oil pick up and learned that brazes such as
    > silver solder that can be applied by a torch will break down over
    > time in sustained temperatures around 300 degrees. The operative
    > phrase is "applied with a torch" as there are brazes used inside
    > turbines or similar applications that are furnace brazed is special
    > atmospheres. Lot of information on brazing on the net. Jerry
    >

   Jerry, but the water jacked is only at around 200F withmaybe
   momentary excursions to 160.
   Also you have the constant cooling of the intake charge.
   Sometime I see my intake pipes beading with condensation on
   the outside. Does not look like the heat would be a problem?
   Bulent

   Just remember guys this is just and experiment and
   not necessary to build a p-port. JB Weld works
   fine if done right.

   Paul Lamar

Paul,

I understand that this is just an experiment, but just how does a p-port get built, then, if not by any of the means already discussed here?

--
Erik Snyman
Messina
South Africa.


This is on the web site so you should read that when you have the time.  http://www.rotaryeng.net/intake.html

Don't use the Lexan for side plates. Not stiff enough.
Use 1/2 inch aluminum plate and large C clamps.

-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.