Subject: tig welding to chrome
From: Rotary Engine
Date: 3/26/2007, 5:05 PM
To: AARotary Engine

   > SS is readily brazed using high or low temperature brazes or
   > solders. Pure copper can be used as a brazing material at 2050 -
   > 2100 F with a hydrogen atmosphere without a flux. Silver and silver
   > alloys used for brazing are used at a much lower temp but usually
   > require a flux. Brazed surfaces must be very clean for a good
   > braze. Joint gap thicknesses of 0.001" - 0.003 " are optimum for
   > high strength. An acetylene flame can be used for the heat source.
   >
   > Joel
   > Over the Hill Materials Engr.


   > I don't think we want to hit the inside of the rotor housing
   > with an acetylene flame.
   >
   > Paul Lamar


  Hi Joel,
  Perhaps you meant with a 'nitrogen' atmosphere?

  Rolf
  --------------------------------------------------
  Rolf

  No, the special belt furnace used had a hydrogen atmosphere.(Some
  applications could use a undissociated ammonia gas.)  Kept the steel
  in a reduced surface condition and improved copper wetting  and
  maintained a bright unoxidized finish during the cooling phase.   These were electronic packages where any flux contamination was a
  disaster.

  Many of our production parts used pure silver or BT (copper - silver
  Eutectic) which were brazed in a Nitrogen atmosphere.  Plating on
  the parts (gold) eliminated the flux requirement.

  I recall that there were some lower temperature silver solders we
  played with that had fairly poor strength  qualities. They probably
  formed unstable solid solutions which caused the failures during
  heat cycle testing.

  I mentioned using acetelyne as a heat source because it is readily
  available and the atmosphere can be kept in a reduced condition.  If
  we are talking about soldering a SS tube to the steel liner in the
  PP, heat could be applied to the inside of the tube and allow it to
  flow in to the tube/liner solder interface such that a minimal
  amount of excess heat would be transferred to the liner.  If I was
  going to do many of these, I would make a resistance heating ring
  that could be inserted into the tube to get a more uniform heat
  distribution.

  Joel


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.