Subject: tig welding to chrome
From: Rotary Engine
Date: 3/26/2007, 11:08 PM
To: AARotary Engine


  I mentioned using acetelyne as a heat source because it is readily
      available and the atmosphere can be kept in a reduced condition.  If
      we are talking about soldering a SS tube to the steel liner in the
      PP, heat could be applied to the inside of the tube and allow it to
      flow in to the tube/liner solder interface such that a minimal
      amount of excess heat would be transferred to the liner.  If I was
      going to do many of these, I would make a resistance heating ring
      that could be inserted into the tube to get a more uniform heat
      distribution.

      Joel

Joel, wouldn't acetelyne require an oxygen feed to be used for heating? Acetelyne burns very dirty in air. I believe the benefit of the H2 furnace is that hydrogen is on of the cleanest of all combustible gasses.

Bill Jepson


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.