Subject: Cutting P Ports
From: Rotary Engine
Date: 3/27/2007, 4:53 PM
To: AARotary Engine



Well, I did it!  I stopped by my friends place and used his Bridgeport
and set up with a good 1 7/8" hole saw.  I measured 8.55" from the base
and it puts you right on the circumference of a recess.  We used a small
end mill to create a flat, then a 1/4" drill all the way through.  We
replace the 1/4" drill that came in the hole saw with a 1/4" rod and
went real slow and lubricated it as it cut.  It takes two passes as you
have to stop when you break into the water jacket from the out side,
then clear the "plug" and keep going.  The next step will be to use a
boring bar to 2".  I don't think it was as difficult as I first
envisioned it to be.  I hope to post pics by this week end.

Joe Berki
Limo EZ

Congratulations Joe.
It was easy wasn't it? :)

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.