Subject: Damper plate torquing conundrum
From: Rotary Engine
Date: 3/27/2007, 7:08 AM
To: AARotary Engine


While reinstalling the engine into my M2 today I ran into a  puzzler - hopefully someone has an obvious solution I'm overlooking.
I can't figure out a way to torque the damper plate bolts to the  proper settings with the engine installed in place.  There is not  room for the torque wrench to squeeze in between the redrive mount  and the damper plate itself.  I am using a pretty hefty 1/2" drive  torque wrench, so maybe I just need to try to find a more delicate  one.  But the primary probem is the depth of the torque wrench +  the length of a 5/8" socket is just too much.
Any clever ideas or exotic tools I don't know about?
Mark Supinski
5/8" crows foot socket

John Gibbons

I don't think crow foot will reach. You can torque the bolt from it's
head side. That's how i have to torque my prop bolts.
Bulent


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.