While reinstalling the engine into my M2 today I ran into a puzzler -
hopefully someone has an obvious solution I'm overlooking.
I can't figure out a way to torque the damper plate bolts to the proper
settings with the engine installed in place. There is not room for the
torque wrench to squeeze in between the redrive mount and the damper
plate itself. I am using a pretty hefty 1/2" drive torque wrench, so
maybe I just need to try to find a more delicate one. But the primary
probem is the depth of the torque wrench + the length of a 5/8" socket
is just too much.
Any clever ideas or exotic tools I don't know about?
Mark Supinski
It seems like I recall being able to rotate the damper plate so that
each bolt could be accessed thru the starter hole. I used a normal
torque wrench with an extension on the socket.
Bob W.