Subject: Damper plate torquing conundrum
From: Rotary Engine
Date: 3/27/2007, 1:13 PM
To: AARotary Engine



    > While reinstalling the engine into my M2 today I ran into a puzzler -
    > hopefully someone has an obvious solution I'm overlooking.
    >
    > I can't figure out a way to torque the damper plate bolts to the
   proper
    > settings with the engine installed in place.  There is not room
   for the
    > torque wrench to squeeze in between the redrive mount and the damper
    > plate itself.  I am using a pretty hefty 1/2" drive torque
   wrench, so
    > maybe I just need to try to find a more delicate one.  But the
   primary
    > probem is the depth of the torque wrench + the length of a 5/8"
   socket
    > is just too much.
    >
    > Any clever ideas or exotic tools I don't know about?
    >
    > Mark Supinski
    >
    >

   It seems like I recall being able to rotate the damper plate so that
   each bolt could be accessed thru the starter hole.  I used a normal
   torque wrench with an extension on the socket.

   Bob W.


Thanks for the input, everyone!

Bob, my starter is moved from the standard 6 o'clock position to the 10
o'clock position.  This was necessary to get the rad under the engine.
I can't remove the starter w/o removing the main mounting bolts - thus
defeating the purpose of keeping everything aligned while I torque down
the damper bolts.

Mark



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.