Subject: tig welding to chrome
From: Rotary Engine
Date: 3/27/2007, 8:44 AM
To: AARotary Engine



   I mentioned using acetelyne as a heat source because it is readily
   available and the atmosphere can be kept in a reduced condition. If
   we are talking about soldering a SS tube to the steel liner in the
   PP, heat could be applied to the inside of the tube and allow it to
   flow in to the tube/liner solder interface such that a minimal
   amount of excess heat would be transferred to the liner. If I was
   going to do many of these, I would make a resistance heating ring
   that could be inserted into the tube to get a more uniform heat
   distribution.

   Joel

   Joel, wouldn't acetelyne require an oxygen feed to be used for heating?
   Acetelyne burns very dirty in air. I believe the benefit of the H2
   furnace is that hydrogen is on of the cleanest of all combustible
   gasses.

   Bill Jepson
   ------------------------------------------------------------------

   Bill,

   Sorry, when I wrote "acetylene", I was inferring the use of an
   oxy-acetylene torch which has the capability of producing a
   reducing, neutral, or oxidizing flame.
   The hydrogen atmosphere in the furnaces was used because of its'
   excellent reducing properties.  The furnaces were electrically
   heated.  The hydrogen was confined to the hot sections of the tunnel
   under positive pressures and was burned only when it exited the
   furnace.  As I recall, we used  nitrogen curtains to contain the
   hydrogen in the furnace.  I don't recall a lot of the details as
   this was 35 years ago when I was a package development engineer in
   the Hermetic Seals division of Motorola.

   Joel

Now that you guys have all this worked out don't go sticking
the rotor housing in a furnace or hitting it with a torch :)

BTW if anybody is worried about the tig welding softening
the aluminum in the tiny area around the 2 inch hole don't.
The saw teeth in the liner and the SS tube will keep the
aluminum in there until it cools. There is also very low
stress on this side of the housing both thermal and otherwise.

Paul Lamar

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.