How to make a two pass rad out of a one pass rad.
Cut a notch in one header tank and insert and tig
weld in a baffle. Then close up the hole and tig weld
in the neck. The other end is just all capped off.
--
Paul Lamar ...No rotor no motor.
-------------------------------------------
Dear Paul
The way you have it in pic is not the cheapest. You do not have to
cut the rad tank that way to make a 2 pass rad out of a single pass. I
didn't do yours that way.
Regards
Ed Klepeis
-----------------------------------------------------------
Don't keep us in suspense Ed. How did you do it?
--
Paul Lamar ...No rotor no motor.
Dear Paul
The way it is done is to cut a slot in the tank all around with a
cut off wheel taking care as to not cut into the core (it could ruin your
day) Make up a sq plate the sticks outside the tank sides about 1/16''. Make
sure it is cut to the contour of the bottom of the core for good sealing.
Than just weld all the edges around three sides.
Regards
Ed Klepeis
Ah Ha that is what I thought. You cannot guarantee there is
no leakage from the hot side to the cool side as the bottom
of the partition is not welded.
My way gives room for welding the bottom of the partition.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.