Subject: the way to do it
From: Rotary Engine
Date: 3/28/2007, 7:23 AM
To: AARotary Engine


    >
    >> How to make a two pass rad out of a one pass rad.
    >>
    >> Cut a notch in one header tank and insert and tig
    >> weld in a baffle. Then close up the hole and tig weld
    >> in the neck. The other end is just all capped off.
    >> --
    >> Paul Lamar ...No rotor no motor.
    >
    > -------------------------------------------
    >
    > Dear Paul
    >         The way you have it in pic is not the cheapest. You do
   not have to
    > cut the rad tank that way to make a 2 pass rad out of a single
   pass. I
    > didn't do yours that way.
    >
    >                 Regards
    >
    >                Ed Klepeis
    > -----------------------------------------------------------
    >
    > Don't keep us in suspense Ed. How did you do it?
    > --
    > Paul Lamar ...No rotor no motor.



   Dear Paul
            The way it is done is to cut  a slot in the tank all around
   with a
   cut off wheel  taking care as to not cut into the core (it could
   ruin your
   day) Make up a sq plate the sticks outside the tank sides about
   1/16''. Make
   sure it is cut to the contour of the bottom of the core for good
   sealing.
   Than just weld all the edges around three sides.

                        Regards

                  Ed Klepeis

   Ah Ha that is what I thought. You cannot guarantee there is
   no leakage from the hot side to the cool side as the bottom
   of the partition is not welded.

   My way gives room for welding the bottom of the partition.

   Paul Lamar ...No rotor no motor.


Why not use an epoxy sealant on that backside edge to seal off
potential  leaks?
Mike Parker

Good idea Mike.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.