Subject: Cutting P ports
From: Rotary Engine
Date: 3/30/2007, 6:01 PM
To: AARotary Engine




> I finished machining both housings today.  Finished up with a boring bar
> slip fit 2" tube. Now all of the questions begin like JB weld or Devcon
> with Al filler.  Should I alodine everything that sees epoxy? How long
> should the tubes be before the slide throttle?  Can the injectors go
> between the slide throttle and the housing? i will try to post some pics
> this weekend got to go to Arkansas for 2 days.
>
> Joe Berki
>
> P Port cutter
>
> Yes on the alodyne but do it just before you bond.
>
> The trick is to get the slide throttle as close to the
> engine as possible and still clear the water pump neck.
> See the attached 3D's. Mark S's are about 2 inches from the
> engine block.
>
> The electronic injectors can go just about anywhere they will
> fit. The constant dribble injectors position is still in debate.
> My latest feeling is they should go in stoves up from the
> exhaust manifold.
>
> -- > Paul Lamar ...No rotor no motor.


Paul,
I am planning on remote mount for the water pump but the exhaust might get
in the way unless I could make the slide throttle slide toward the
bellhousing end.  I thought  after you alodined the surface was protected
from any oxidation.

Joe

Sliding towards the bell housing may be a problem due
to the length of the slide.

It says in the bonding prep kit that you need to bond it
as soon as possible.

Here are some old 3D's on the remote mount water pump.
Don't got no more. All gone :)
-- 
Paul Lamar ...No rotor no motor.

May have to build a modified slide throttle that is not as long maybe two
units that slide toward each other with linkage.  I thought I would use the
Toyota pump since all of your castings are gone.

Joe Berki

How much shorter does it have to be? You can take two inches
out of the overall length by using a Teflon coated aluminum slide
and taping it directly for the 10-32 throttle cable end.
No round steel button in round hole in Teflon needed.
a more expensive labor intensive way of doing it.
Also more friction in the mechanism as the aluminum edge
is sliding on the aluminum spacer.

If you do design your own don't forget the slide must be totally
sealed. Raw fuel accumulates in the slide and must not escape.
It must be sucked into the engine sooner or later.
-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.