Subject: Cutting P ports
From: Rotary Engine
Date: 3/31/2007, 2:04 PM
To: AARotary Engine




Here are the housings so far.

Joe Berki

Those look like pretty good P-port holes Joe.
Are these junk rotor housings or are you going to use them?
If you are not going to use them it would help if you
did the SS tube tig welding experiment on them.
-- 
Paul Lamar ...No rotor no motor.


What is the great stainless steel experiment consist of?

Joe

Cutting the end of a two inch stainless steel tube to just fit
the contours of the trochoid surface and tig welding
it the rotor housings mild steel liner from inside.

-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.