Billions have been spent over the years getting
one percent more efficiency out of car engines.
Curtis Wright (no less), John Deere, Rotary Power
International, Mazda and lately Mistral have all
spent as much as a 100 million dollars or more (in
total) on the rotary engine attempting to get the
BSFC down from .47 BSFC to .44 BSFC.
One of the same ideas that are in regular recip
operations is what is working in vastly improving fuel
economy in a wide variety of vehicles.
I am sure everyone on the list is well aware that a
4-stroke automobile engine has to be operated over a
wide range of engine speed and engine load. And it's
this need to make decent power and a reasonably even
torque curve that causes a lot of the inefficiency in
car engine operation. The ultimate (for automotive
ICEs), at this point, is a changeable restriction
exhaust, variable cam timing and lift, and
variable-length intake tracts. With enough electronic
wizardry, we can bring the engine into "best tune"
over a wide range of engine speeds and loads, since we
can optimize overlap, valve opening time, and intake
and exhaust tuning to all work together throughout the
operating range.
However, there's another route that is delivering a
good percentage of the power and much more efficiency
compared to the above (heavy, expensive, requiring
expensive maintenance over time) wizardry:
Make a small, fairly low-power gasoline engine that is
perfectly tuned for full load at a single engine
speed. Then stick a big generator on the end, get
some high-efficiency batteries, and set up a
regenerative braking system. Since electric motors
have max torque at all rotational speeds, you can be
very quick off the line, even faster than most
ICE-powered road vehicles. If you turbocharge the
engine, you get back some of the heat wasted down the
tailpipe; I've seen people talking about doing
something with the heat in the coolant and using some
of that for motive power generation, but I don't
really know a lot about that.
Yep, typical hybrid cars. That's how they manage the
fuel economy numbers they do, especially high in
stop-and-go city driving (where the kinetic energy is
largely recaptured by regenerative braking). There
are, of course, many cars that do NOT use what amounts
to a large gasoline-powered generator; those typically
have a small ICE that is less flexible than a regular
car ICE, but much more flexible than the single load
and speed engine I just noted. This is because there
are weight and construction limits today with battery
technology, powerful electric motors, etc. that limit
the acceleration of these vehicles when run on
electric motors alone. This will change, though, and
very rapidly.
Even with the loss of energy from engine to generator
to battery to motor(s), I'd suspect the small,
single-load, single-speed ICE would be notably more
efficient than a typical automotive ICE -- which is
pretty much what you're talking about with the "tiny
rotor" for cruise while deactivating the main rotors.
And no, I don't think we'll be seeing hybrid aircraft
in the foreseeable future. ;) Just my $0.02, and my
encouragement for this idea, and any other ideas that
bring forward engineering and usable real-world
solutions.
Oh, and EGR is not only for emissions, but also to
greatly reduce pumping losses at part-throttle cruise.
It does both admirably, which is why it's been
standard on cars for quite some time now. This
doesn't have any application in aircraft, either,
since I think the only time you guys are using small
throttle openings is while waiting to taxi and perhaps
during landing. :D
Adam Wade
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.