Subject: 2nd gen sensors
From: Rotary Engine
Date: 4/6/2007, 4:27 PM
To: AARotary Engine


Thanks for all the info on the sensors.  The two that cannot be measured
are switches.  I went to Tracy's sight and looked in the EM2 manual he
has on line and found stuff at egauges.com.  The only one I did not see
Tracy call out was water temp.  Does anyone have a recommendation?  I
will probably try one of the Mazda senders for this experiment but will
use the ones Tracy recommends for flight.

Joe Berki
Limo EZ
experimenting with a 88 N/A and a 89 N/A

The same probe Tracy uses for water temp works good for oil temp.
Tracy's EM2 can be calibrated to almost any sensor you want to use.

Bob W.

-- 
N93BD - Rotary Powered BD-4 - http://www.bob-white.com
3.8 Hours Total Time and holding
Cables for your rotary installation - http://www.roblinphoto.com/shop/



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.