Subject: Carbon Build Up in Primary Intake Ports
From: Rotary Engine
Date: 4/7/2007, 7:17 AM
To: AARotary Engine


    Hello Paul,
    I was looking over my 20B block today and preparing to start the
    disassembly process when I noticed something that seemed unusual to me.
    Please understand that while I have quite a lot of experience with
    piston engines, my rotary experience is negligible.  I noticed that
    there was a LOT of carbon build up in the Primary Intake Ports while the
    smaller secondary ports were squeaky clean.  Is this normal?  I've seen
    exhaust ports do this but usually the intake ports are clean.....aren't
    they???
    Don

    That is a little strange. I don't recall seeing that on
    a two rotor. I wonder the history of this particular 3 rotor.
    Perhaps it was loafed around town its entire life. Perhaps
    the turbo charger oil seal was leaking and oil was being sucked into
    the intake manifold.

    Paul Lamar ...No rotor no motor.



Paul,
It looks like could be exhaust residue.  My 20B had exhaust port inserts
with passages going back up to the intake, but I don't remember
exactly where they terminated.  I do remember that there was a lot of
buildup in them.  I removed the 20B exhaust inserts and replaced them
with 13B turbo inserts.  Could this be residue from the exhaust
recirculating back into the primary intake ports?

Mark S.

The purpose of that is to warm the cold side of the engine
so the engine does not deflect into a banana shape. The flow goes into
the center housing up and over to the rotor housings  down and back
to the end housing and exhaust ports.

This can be seen in the book Rotary engine downloaded from:
http://www.wankel.net/~krwright/cars/rx7/manuals.html

Everybody download both version of this book. It is the bible of the
rotary engine.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.