I use the Mazda supplied sensor for the coolant temp at the pump outlet. It
works fine with the EM2, you just have to do the calibration. Even for the
channels where I used the same sensors as Tracy, I found I had to adjust the
calibration data to get good readings. I used ice water/hot water; or hand
held pyrometer aimed at spots of flat black paint to calibrate all air and
liquid temp channels.
Al
BTW Al, how come your engine is out of the airplane?
Paul Lamar
---------------------------------\
I think I mentioned it here a week or so ago. I discovered there was a
small leak of coolant into the oil pan. My mount requires removing the
engine from the plane in order to get the pan off.
With the pan off and pressurizing the coolant, it was quickly apparent that
the tension bolt just to the right of the oil pump had not been tightened,
and coolant was leaking about a drop every 4 - 5 seconds. Torquing the bolt
immediately corrected the problem. I then checked the other 21 mm (head)
bolt at the front behind the CAS. It also had not been tightened.
A year ago I had a leak at the rear housing, and removed the re-drive to
take the bolt out and replace the seal. I discovered that neither of the
two 21 mm bolts at the back had been tightened. At the time, it didn't
occur to me that there may be others at the front that were loose, and in
bringing it to Atkins attention (the supplier/re-builder of the engine) he
didn't suggest further checks either. Apparently whoever at his shop put
the engine together torqued all the 17 mm bolts, but forgot to torque the 21
mm bolts, front and back. Pretty unbelievable.
I could find no evidence of consequential damage, so the engine is back on
and running fine.
Al
I am very glad you have not given up on the rotary :)
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.