Subject: exh gas heating of,the cool side
From: Rotary Engine
Date: 4/8/2007, 11:16 AM
To: AARotary Engine


It seems from this info that the exh gas heating of
the cool side of the housings is a necessary thing. Is
there any easy way to retain this feature with the use
of P-ports?

regards, Robert

That is an interesting question as there are two kinds of
center housings. The turbo center housings are a different
casting and they appear not to pass the exhaust heated
gases into the rotor housings. So far I have a cutaway
turbo center housing but not one for a six port center
housing. Things are still a bit of a mystery on this
subject. Many p-port engines have been built over
the years. I have no info on drawbacks if any of using
a six port center housing for a p-port engine.
People mix and match all sorts of combinations of housings all
the time and you never hear of problems specifically
related to the presences or lack of exhaust heat in
the rotor housings. Perhaps Mazda felt it was more
important than it proved to be in practice.
Merely using an after market exhaust  header on a rotary
engine will disable part of the exhaust gas heating system.

I'll forward this to Jim Mederer and perhaps he will
shed some light. Jim has built many many P-port engines
over the last 35 years.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.