Subject: 1986 13B Exhaust restriction removal
From: Rotary Engine
Date: 4/9/2007, 12:40 AM
To: AARotary Engine


Hi Paul,

I cut away the exhaust port restriction, now I have a gap as you can
see on the Picture, could this cause the housing to overheat in this
area?

Thanks,

JP

Hard to say. It might work. And then again it might not.
If you can find a couple of turbo rotor housings and get
the inserts out of them and install them into your rotor
housings that would probably be a safer thing to do as far as
the durability of your rotor housings is concerned. Here are
some pictures of ported exhaust ports that work.

On the other hand I don't think the engine would stop running
if some of the aluminum in this area melted.

Once the exhaust flange is bolted on there is no exhaust gas flow
into this area as there is no way for it to get out.


-- 
Paul Lamar ...No rotor no motor.

Hi JP;
Many people have ground away the NA splitter wings.  I have never seen
only the NA insert lip removed.
I have heard of (good turbo) dyno results with the entire insert removed
but never any long term results.
The exhaust area is surrounded by thermal mass and coolant flow.
Without any direct exhaust gas
flow I'm guessing this area might suffer slightly (if any) reduced life.
As per the previous email, removing sleeves can sometimes be a pain.

Cheers
Cary


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.