Subject: Epoxy for P-ports E
From: Rotary Engine
Date: 4/9/2007, 2:48 PM
To: Rotary Engine


  Paul,
  What epoxy did Powersport use to glue their tubes in? Is the same epoxy
  used for plugging the intake passages?

  Joe Berki

  "Hi Paul,

  WE NEVER have used Devcon on a peripheral port sleeve.
  We do use Devcon cast iron to fill the side ports, but that's all.
  We do use Araldite to seal the threads when we screw in the threaded
  sleeve. WE still use an o-ring to seal the intake from the water.

  Jim"

  Jim builds the p-port differently. He bores the hole in perpendicular
  to the trochoid surface and threads the outer wall and the tube or
  insert as
  he calls it. Then he has a shoulder with an O-ring on the inner wall.
  He then screws the tube in. At that point you must connect the tube
  to the runner with a rubber hose.

  I have recently spent a LOT of time and a LOT of money developing
  the JB Weld process. Deviate from this process at your own
  risk. Believe me... it is not as easy as it looks. There are
  several steps that MUST be done right. One screw up and you
  will have to start over. I made a huge error in the beginning
  by buying the wrong epoxy. Mark Supinski will verify what I say.

  I will be glad to walk you through them again.

  I have cooked JB Weld in an oven at 300 degrees F. I KNOW it does
  the job.

  JB Weld works fine to plug the side ports.

  Paul Lamar ...No rotor no motor.


  Paul, Have you ever used Lumiweld? do know people that have use it to
  repaire alloy cam covers,what do you think about useing it to fix in
  alloy tubes for peripheral port ......
  robert pay. old rotary

  Never heard of it until now.

  Paul Lamar ...No rotor no motor.

  Paul,
     This process is the one currently on your website, is it not?
     Allen
  Houston


  Yes it is. It needs a bit of minor updating.

  Paul Lamar

  The Rotary Engine NewsLetter. Powered by Linux.
  ACRE NL web site. http://www.rotaryeng.net
  Copyright 1998-2006 All world wide rights reserved.