I bought 3 13B engines sight unseen. They were described as rebuildable,
two 91s and a 86. It turns out they were a box full of parts. I thought
they were assembled engines, but then I didn't ask. Dumb me.
Some of the parts are marked as #1, #2 and #3, all 3 e-shafts and some
of the rotors and some of the other parts. None of the counter weights
are marked. I can't see any complete set of parts that are marked the
same to assemble a complete engine.
In general the parts do indeed look re-usable. The ones that we have
measured pass Mazda's tests.
The problem is that I don't know which goes with which. I am especially
concerned about the counter weights. None of the counter weights are
marked.
Is it permissible to just assemble an engine with whatever parts seem to
belong to each other?
What to do?
Doc Custer
Retired Software Engineer and sometime Audiologist
---------------------------------------------------
As well you should be Doc :)
I don't know how to identify counter weights and I doubt any
of the shop manuals tell you how either. I could be wrong
but your best bet is call Mazdatrix and ask for John.
Other than that people mix and match all the time as long
as the rotors are the same. I would for sure have it professionally
dynamically balanced.
Take some detailed pictures of the counter weights and
upload them. Some one on here might recognize them.
Paul Lamar ...No rotor no motor.
Hi Doc;
You can assemble anything and it will run, for a while...:) The short
answer is no.
Front and rear counterweights(CW) (or flywheel which have the CW cast
into them)
must match the rotor series. e.g. series4 OR series5/6 are the same.
Many CWs look very similar - the easiest way is to weigh them.
Digital scales with gram accuracy are cheap.
Mazdatrix has a FAQ: (plus lots of other good info they have been kind
enough to share)
http://www.mazdatrix.com/faq/Rcounterweights.htm
Here is another thread:
http://www.rx7club.com/showthread.php?t=467955&highlight=rear+counterweight+specs
Generally:
S4 rear CW = 1855g, typically +-5g, 1 or 2 balance holes
S4 front CW = can't find the info right now.
S5 rear CW = 1820g +10g?, typically 2 or 3 balance holes
S5 front CW ~= 1200g with washer
S6 are the same as S5, ones I have measured are usually lighter by a
gram or so.
Here are some photos comparing CWs, I'm can't remember where I found
these?
Also attached is a pic from nopistons.com on balancing:
Cheers
Cary
Thanks a bunch, Cary. It helps a lot.
Doc Custer
Retired Software Engineer and sometime Audiologist
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.