Subject: exh gas heating of,the cool side
From: Rotary Engine
Date: 4/9/2007, 10:25 AM
To: AARotary Engine


I suspect what happened is around about 1988 or 1989
Mazda changed the alloy of the rotor housings to a
low thermal expansion high silicon content aluminum.
Just about the same time they introduced the first
turbo rotary.
Paul Lamar


The first production turbo rotary was released in
1983, as a JDM-only vehicle.  Details here:
<http://cp_www.tripod.com/rotary/pg18.htm>

I do not know if it used a different center section
from other 12A engines of the day, however.  I tend to
doubt they were using the 88-up metallurgy, but you
never know.

Adam Wade

"The 12A turbo also has a knock-prevention system. Mazda engineers
found in developing the engine that knocking would only occur under
certain operating conditions: in a 2500-3750 rpm zone when intake
temperature exceeds 85 degrees celcius [185 F].
The system, comprising of ignition-pulse, intake-temperature and
boost sensors, detects this knock-prone zone and feeds a signal
to the emission-control and fuel-injection computers, which in
turn call for ignition retard and more fuel (in the latest 13B
turbo a more usual piezometric knock sensor is used)."

This is the first time I have seen such a knock air temp number quoted
for a rotary. The Allison V12 corresponding number was 140 F.
The knock sensor is after the fact. One knock can fracture an
apex seal. Knowing the turbo intake air temperature one can anticipate
the conditions that lead to knock.

I have a Jack Yamaguchi book coauthored by John Dinkel (who happens
to be on this list) published in 1992. Is this the book the above site
is referring to?. If so I saw no reference in that book to a 12A
turbo. Is there another RX7 book by Jack... John?

BTW John I got to come down to your house someday and get you
to sign my copy :) Koby already signed it.

Paul Lamar

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.