Hi Don;
Also meant to ask if you have removed and replaced the stock
20B
exhaust
sleeve inserts.
I have heard they are quite restrictive and many people replace
them
with 13b turbo inserts.
Although removing them is a good way to break taps...
Cheers
Cary
I haven't removed my exhaust inserts yet, but I've been considering
it.
Any tips on how to do this? Why not just port out the ones that
are
already there?
Don
Hi Don;
I have had limited success...
Some people seem to have it down to an art, there may be an easier way.
I drilled and tapped the roll pins to insert the highest strength bolt I
could find.
I have broken several taps this way.
A small hit with a hammer will help loosen the pins before being tapped.
http://bdc.cyberosity.com/v/Technical/RollPin-Removal/
I have also heard of people drilling them out completely and others
welding something to grip to the pin.
http://www.nopistons.com/forums/index.php?showtopic=38897
I would practice on a junk housing first.
Cheers
Cary
Hi, I am happy to help on this one,
It is easy to remove, just use a small tap, screw it in the retaining
sleeve on the side of the housing, clamp the end of the tap it with a
vice grip at 90 degrees and using a small hammer hit the vise grip
lightly slipping the sleeve out.
I did it this way without breaking anything.
JP
This is the best I could do to cut the obstruction out of the exhaust port,
At first after removing the insert and cutting the obstruction with a metal
saw
I had this lip in the way, then I remove the insert again and hammer down
the lip,
last try before getting turbo inserts.
I think now it is OK, sorry for the pictures being a bit flew, what do you
think Paul?
JP
Looks like it is worth a try. Just inspect it after the first
flight and then every few hours for awhile.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.