Hello Paul,
I am getting close to re-assemble my engine using Tracy's kit
but before I want to make sure all holes are plugged:
Engine Pictures 1: small hole at the top, what is the purpose of this one?
--------------------------------------------------------------
Vent to the oil breathing system. Usually routed to the
intake manifold but you can block it off. PL
-----------------------------------------------
Engine Pictures 2: small square hole, is this part of intake as well?
------------------------------------------------------
Exhaust heat to the intake manifold. Can be blocked off. PL
----------------------------------------------------------
Engine Pictures 3: I blocked the injector holes using the injector plastic
bushings cutting off the bottom piece of it a bit so it does not block the intake passage
and filled them up with metal putty, is there a risk for these to pop up?
-----------------------------------------
Where are you going to put your primary injectors?
Make sure none of this stuff can find its way into
the engine as it could fracture an apex seal. PL
------------------------------------------------
A few more in the next email
JP
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.