Subject: Still a few unkown openings (Prime Injectors)
From: Rotary Engine
Date: 4/12/2007, 2:13 AM
To: AARotary Engine


Engine Pictures 3: I blocked the injector holes using the injector  plastic
bushings cutting off the bottom piece of it a bit so it does not  block the intake passage
and  filled them up with metal putty, is there a risk for these to  pop up?
-----------------------------------------
Where are you going to put your primary injectors?
Make sure none of this stuff can find its way into
the engine as it could fracture an apex seal. PL
------------------------------------------------
A few more in the next email


JP


Why would you do That? Hope you did not plug them instead of the oil
injectors?
Buly


I am happy to find out now I was going wrong on this one!!!
My understanding was one fuel rail with 4 injectors across
4 intake runners.  If you look at the attached picture I believe
it is blocked.

I am opened to suggestions on how to deal with this, I am planning
to use the EC2  from Tracy.

Thanks  JP

By the way I blocked the oil injectors too,
I will add 1 part of oil per 100 parts of fuel for every refill.



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.