I bought my Cosmo 13B from a local engine importer, and it was a Twin
Sequential Turbo. Now it is running as a NA, since the
Lamar Stock Turbo Experiment failed :)
Buly
Yes it is my stock turbo but not failed yet. The first time I saw
it on the Mecanair (now Mistral) rotary aircraft engine at OSH I said:
"Wow look at that. A stock 1989-1991 Mazda 13B turbo rotary aircraft
engine." Water cooled, waste gate, heat shielded and all plumbed up
with a very compact installation. Perfect for aircraft use.
Unfortunately I under
estimated the HP of the turbine and over estimated the effectiveness
of the waste gate. John Slade installed one and proceeded to blow it
up due to a combination of over temp. and over rev. Mecanair
became Mistral and Mistral tasked Emory Riddle to install and test the turbo
engine in a Piper Arrow and proceeded to blow the turbo up.
Unfortunately they did not tell us about that until way
later. Dave Leonard installed the Mazda turbo engine in his RV6 and
proceeded to blow up the turbo.
By that time I had figgered out the turbine would make an excellent
turbo compound turbine because of the huge amount of excess HP
it possessed. The reason it has so much HP is it is needed to
rapidly accelerate the turbo charger for use in cars that need
the boost RIGHT NOW. Not in a second or two.
You were not on the
Newsletter Buly at that time so you proceeded to install the
stock turbo and blow it up also. My main man Dave Leonard persevered,
figured out the problem and fixed it by using a larger compressor
to load and slow down the turbine. He also bored out the hole in
the waste gate and removed the waste gate flapper. Apparently it
is now fixed. We will soon know as Dave is getting ready to fly
again after his fine service tour in Iraq. Thank you again Dave
for all you do here and in Iraq.
------------------------------------------------------
It is not too difficult to match the compressor to the
amount of engine HP you would like to generate. That is the easy
part. We have several spread sheets from different people
that achieve that task. I suspect the problem is the turbines
that go with these compressors are way too powerful for aircraft
use. If somebody went to Garrett and said I won't x compressor map
Garrett would give them a turbo charger turbine designed for
automotive use. In other words a turbo charger that would accelerate
rapidly and then be backed off to shift. If run at sustained high
power it would soon over rev and explode I have no doubt.
We need HP data on Garret turbines that will
not over rev the turbochargers at steady state high altitude
use. So far and as far as I can tell that info is not fourth
coming from Garrett. I suspect we need an A/R over one.
I also suspect no off the shelf automotive turbo charger
is going to work. We will have to mix and match turbine with
compressor. Garrett does not discuss this scenario on their
web site. Also they donnot discuss turbocharger acceleration.
If we knew the rotating moment of inertia for the
compressor/shaft/turbine and the acceleration in terms of RPM per second
per second we could figure out the turbine HP.
http://www.turbobygarrett.com/turbobygarrett/tech_center/turbo_tech103.html
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.