I think Buly bought a NA 13B Cosmo engine
from Japan.
Paul Lamar ...No rotor no motor.
I bought my Cosmo 13B from a local engine importer, and it was a Twin
Sequential Turbo. Now it is running as a NA, since the
Lamar Stock Turbo Experiment failed :)
Buly
Yes it is my stock turbo but not failed yet. The first time I saw
it on the Mecanair (now Mistral) rotary aircraft engine at OSH I said:
"Wow look at that. A stock 1989-1991 Mazda 13B turbo rotary aircraft
engine." Water cooled, waste gate, heat shielded and all plumbed up
with a very compact installation. Perfect for aircraft use.
Unfortunately I under
estimated the HP of the turbine and over estimated the effectiveness
of the waste gate. John Slade installed one and proceeded to blow it
up due to a combination of over temp. and over rev. Mecanair
became Mistral and Mistral tasked Emory Riddle to install and test the turbo
engine in a Piper Arrow and proceeded to blow the turbo up.
Unfortunately they did not tell us about that until way
later. Dave Leonard installed the Mazda turbo engine in his RV6 and
proceeded to blow up the turbo.
By that time I had figgered out the turbine would make an excellent
turbo compound turbine because of the huge amount of excess HP
it possessed. The reason it has so much HP is it is needed to
rapidly accelerate the turbo charger for use in cars that need
the boost RIGHT NOW. Not in a second or two.
You were not on the
Newsletter Buly at that time so you proceeded to install the
stock turbo and blow it up also. My main man Dave Leonard persevered,
figured out the problem and fixed it by using a larger compressor
to load and slow down the turbine. He also bored out the hole in
the waste gate and removed the waste gate flapper. Apparently it
is now fixed. We will soon know as Dave is getting ready to fly
again after his fine service tour in Iraq. Thank you again Dave
for all you do here and in Iraq.
BTW Buly I can always tell when I go somewhere and shutdown the
Newsletter, who reads ALL the messages before posting
and who doesn't :) I am in Tombstone AZ and was lucky enough
to find a reasonably priced motel that had wireless.
Paul Lamar ...No rotor no motor.
Well, isn't that a fine "how-ya-do"? I have the Mistral intake and was
fudging about for hours on how to get the turbo manifold and turbo to fit
since the Mistral Intake has in injector rail directly interfering with
where the turbo assembly should be. I remember reading that the injectors
were placed there since that was determined to be the best
location...........BUT, NOOOOOOW, as I see their turbo install, the injector
rail is missing as the turbo is slotted in that location. GEEEEEESH. So
it goes.
Back to wire runs.
All the best,
Chris
I am sure we can make it work Chris. Send me some pictures of
what you have so far as I recall there are more than one Mistral
manifolds.
What does Francois have to say about it.
--
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.