Subject: Turbochart Latest Version (Here's Version 3.9)
From: Rotary Engine
Date: 4/23/2007, 5:15 PM
To: AARotary Engine






    snip.....


    When you enter an actual displacement of 2.6 L equivalent
    displacement becomes wrong.
    Your formula for equivalent displacement is obviously wrong.

    The volumetric shown efficiency is also too low. It should be at
    least 100% for a side
    port and 120% for a P-port.

    Here is what you get with a VE of 115% on gasoline which correlates
    well with what people are getting out of turbocharged 13Bs.

    Also a BSFC of .42 is pretty good at sea level for the turbo compound
    with a TIT of 1750 F.

    Congratulations. Other than the minor problem with the equivalent
    displacement :)

    -----------------------------------------------------

    Op's I just realized that is at zero boost.
    There is a serious mistake in there somewhere. That is probably what is
    fooling you on the displacement.

    Paul Lamar ...No rotor no motor.

    Paul,

    There is no mistake. Everything calculates perfectly.

    What exactly is confusing you? The fact that there is turbine work
    and hp even without boost.

    Of course there is. Even when the compressor is not called upon to
    make boost, there is still flow through the turbine, unless you open
    a wastegate.

    The spreadsheet treats the turbine and compressor as separate
    entities. The compressor is only called upon to make boost when you
    increase manifold pressure above ambient.

    The turbine always has flow through it because the exhaust keeps
    flowing -- even without boost, no?

    There is nothing wrong with displacement. Equivalent displacement is
    double actual displacement.

    You entered 2600 cc into actual displacement, for an equivalent
    displacement of 5200 cc. This would be a 4-rotor engine. Engine
    power, mass flow, etc. are shown accordingly.

    As for VE, I've suggested more conservative numbers. I've seen .94
    quoted in the literature for a side port, and 1.15 seems to be a
    conservative suggestion for p-port.

    Anyway, I've increased the range that can be entered, from .8 to
    1.2, so you can do as you please.

    I've also changed the inlet depression feature to take into account
    ram air, if it is present. So now the user can enter values of -2 to
    +2. I've also increased the mixture range for ethanol to 9 at full
    rich. This is realistic for ethanol.

    Please go ahead and verify with your own flow numbers nad charts.
    Enter the displacement, VE, etc. and chaeck against your charts.

    I've entered the values from your chart in the attached
    spreadsheet, version 3.9. Flow comes out to 220 cfm, which is
    exactly what your chart shows.

    Regards,

    Gordon.


This spread sheet should work with any displacement engine you put in it.
Piston or rotary. It does not. It doubles the displacement. That is wrong.
This spread sheet is useless until that is fixed. It should not be specific to
a Mazda rotary. The only difference between a rotary and any other engine is
VE and RPM.  I put in a 2.6L piston engine normally aspirated at 6000 RPM
with a VE of 80% and it gave me 285 HP. NO WAY!!!!!!!!!!!!!!!!!!!!

BTW why limit the engines to 2.6L???

Paul Lamar

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.