Hi Paul,

   I have been following your list for some time and am to the point
   that I need to get an engine mount. I stopped by Jerry Hey's
   Saturday and talked to him. His work is very good and I would like
   him to make a mount for me. He told me you could make a rendering of
   the mount for him to build it. If this is possible I would greatly
   appreciate it. The mount is for a RV-7A. Let me know what dimensions
   you will need if any.

   Thanks,
   Dale Harvey

   I need a sketch of the firewall outline, position of the thrust line,
   angular off sets if any and the position of the hard points. A piece
   of brown wrapping paper taped to the firewall is a simple and fairly
   accurate
   way of doing it. Fold up the paper and send it to me. Mylar drawing
   paper
   is even more accurate as it is semi transparent and temperature stable.
   --
   Paul Lamar ...No rotor no motor.

   Thanks Paul, I'll try to find some Mylar paper and make a sketch.
   What address should I send this to?

   Dale Harvey

Mail it to me at:

830 East Santa Maria St
Suite 303 <<<<<<<<<<<<<very important
Santa Paula CA 93060

ON second thought it is an "A" meaning nose gear aircraft.
It is better and cheaper to modify the Vans mount. No need for firewall dimensions.
Jerry can get all the dimensions he needs off the stock mount.

I'll still do a 3D but it will be based on the Vans mount.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.