Subject: Doc' slide throttle at Sun n Fun
From: Rotary Engine
Date: 4/24/2007, 6:53 PM
To: AARotary Engine

Here is Doc and his three generation family.
He has done a very fine job on this production low aerodynamic loss
p-port slide throttle.

He is going to ship it to me and I will see if I can get Mazdatrix or
Racing Beat to distribute it.
-- Paul Lamar ...No rotor no motor.

Paul, & Doc,
Very nice work Doc. One thing you might want to watch out for.
Your intake tube flanges (the square ones) are anodized. This can
make them  difficult to weld to the intake tubes. Press fitting them
is probably ok but you should leave some of them in raw aluminum.
FWIW
Bill Jepson

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.