Subject: Water to oil cooler
From: Rotary Engine
Date: 4/24/2007, 7:11 PM
To: AARotary Engine



Any one who went to SnF see the water to oil cooler that was featured in
Contact?  Does anyone know how effective it is?  Could be an alternative
if the air to oil unit doesn't work one cold increase the size of their
rad and mount this unit under the cowl.  Any thoughts?

Joe Berki
Limo EZ

Not recommended. All the heat goes into the water cooling system which
already has plenty to do. In other words the size of the water cooling system
needs to be a third larger. One third of the rotary engine cooling is done by the oil.
The rate and direction of heat transfer depends on the difference in temperature
of the two liquids. The oil must be much hotter than the water in order to
transfer significant heat.

A water cooling system can fail if it boils over.
This does not happen with an oil to air heat exchanger. Oil does not boil
until a very high temperature is reached therefore in a sense it is negative
feed back system as the hotter the oil the greater the heat transfer.

It is also a parallel cooling system. If the water cooling system fails
it gives you more time to get back on the ground. Power Sport tried it a few years
ago and correctly gave up. What works in a car does not necessarily work in
an airplane.

Speaking of cars Mazda themselves tried it in early 12A powered RX7's
and gave up. All RX7's since about early 1980's there abouts have had oil coolers.
Late model high power engines have two oil coolers. Both third gen and high power
RX8 engines.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.