Here is Doc and his three generation family.
He has done a very fine job on this production low aerodynamic loss
p-port slide throttle.
He is going to ship it to me and I will see if I can get Mazdatrix or
Racing Beat to distribute it.
--
Paul Lamar ...No rotor no motor.
Doc
Nice jog. Is Mazdatrix, or anyone going to actually test the slide
throttle performance and operation on a running engine before selling it?
Doug
We already did that Doug. Perhaps you were in Nepal at the time.
240 HP at 6500 RPM. Mark Suspinski is getting ready to fly it soon.
Of course slide throttles have been used on Mazda engines before.
In fact they were used on the Lemans winning Mazda four rotor p-port engine.
They date back on car engines close to 100 years.
Paul Lamar
Paul,
Yes I saw the data. Actually I understood it you didn't use the slide
throttle and had to quickly rig up Webber Carbs for the test. That version
of the slide throttle had a very thin Teflon sheet as I recall. Perhaps you
tested again this year when I was in Nepal? .
Doug Fir
The engine ran fine on the dyno with the slide throttle. I was unable to get the mixture
to stabilize because the dyno load is different than prop load and we were using
Tracy's EFI system with the slide throttle. Tracy's EFI system is designed for a fixed
pitch prop load which is a strict function of RPM. In other words for each RPM there
is a given single load. Dyno load is like car load in that the load can vary all over
the lot at any given RPM. That takes more sophisticated sensors than Tracy provides.
Namely it takes a mass air flow sensor and probably a throttle position sensor. Tracy
system is working on manifold air pressure, RPM and intake air temperature alone. A
carburetor works on an airflow sensor (a venturi) so it does a much better job of
adjusting the mixture at any given RPM for a wide range of loads.
That is not to say Tracy's system will not work on a dyno. At $650 a day I ran
out of time and money to get it tuned properly. I suspect Tracy's system is going
to have a hard time dealing with a variable pitch prop load automatically. You will
need to fine tune the mixture manually as you change the pitch and load at any given
RPM.
In your case you are using a fixed pitch prop based dyno so you will find Tracy's system
will work fine and be much quicker to tune.
These Teflon slide throttles are not rocket science. There is absolutely no
reason they won't work with a fixed pitch prop load and Tracy's system.
No different than a butter fly throttle. The thickness of the Teflon slide
has nothing to do with it.
Mark Supinski also ran the p-port slide throttle engine with prop load and Tracy's
EFI system with the same slide thickness Doc is now building. It may have been while you
were in Nepal. It ran fine as far as I know but it was leaking coolant into the
combustion chamber so we had to start over, disassemble the engine, replace and re-seal
the p-port tubes at great expense for both Mark and I. Thank you again Mark for your
perseverance, time and money. I used the wrong epoxy and improper aluminum preparation
on the first go around. It is called R&D. Long story.
BTW Mark Steitle agreed to try tig welding a p-port SS tube to the steel liner on his
junk p-port rotor housing while I was in Austin a week ago Sunday.
Mark Steitle is a very talented tig welder among his many other excellent fabrication
skills.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.