Paul, and the group
A lot has been written about aftermarket computers for our aero
conversions. However, is there any reason why the stock engine
computer
can not be used? Does anyone have any experience in using
stock? Good or
bad? How does one go about configuring the stock unit for
aircraft use?
Engine is a 13b single turbo with fuel injection.
Thanks and regards,
--
Erik Snyman
Messina
South Africa.
Perry Mick has over 500 hours with the stock computer. There are a
few tricks
however. The stock computer takes in some data from certain
places that
don't exist in an airplane. I'll let Perry explain it if he
doesn't
mind.
As I recall the big hang up is leaning it. Perry was working on a
solution
for that as I recall.
---------------------------------------------------------------------
BTW HKS makes a bunch of add on device that change the output
of the
varies
RX8 engine sensors in real time. I suspect they are basically
PICAXEs with
analog to digital converters that take in the sensor voltage and
covert it to a
different analog output voltage to be fed into the stock OEM
computer.
I think this is the way they did it with this 390 HP turbo RX8
engine.
http://www.rotaryeng.net/Turbo-RX8a.jpg
For example if you wanted to lean the OEM computer for use at
high altitude you would take in the mass air flow sensor output
voltage
and change it so the the stock OEM computer thought it was
getting less
air than it actually was. Consequently it would put out less fuel.
Pretty easy to do with a $30 PICAXE.
Paul Lamar ...No rotor no motor.
Paul,
I would have reservations about using an OEM computer at high
altitudes. (Or any computer that has not been proven for aircraft
use, for that matter.)
The reason is that as atmospheric pressure drops, it becomes easier
for electrical current to jump gaps and end up where it's not
supposed to. We see this in aircraft magnetos that have arc-over at
higher altitudes. That's why some of the turbocharged planes have
pressurized magnetos.
It is anyone's guess how the electronics inside an engine computer
will behave at pressure of even half that at sea level (15,000 feet
approx.). They may work fine, they may not.
My own opinion is that I would rather not fly a stock engine
computer above 10 to 12 thousand feet. At this altitude the stock
computer should be able to handle the leaning anyway.
For any serious flying above that, my preference is for a purely
mechanical ignition system (flywheel magneto, a la Rotax), and carb
or mechanical fuel injection.
Regards,
Gordon.
Those are real high voltages Gordon. Not a problem at 5 volts.
Sparks are
20,000 volts and up.
Most engine computers have a coating over the parts called a
conformal
coating which acts as an insulator. At Pikes peak in Colorado there
is a road to the top at 14,000 feet as I recall where the
public can and do drive to the top. Perry has had no trouble with
this in
over 500 hours.
Paul Lamar ...No rotor no motor.
Paul,
Yes, the voltage in magnetos is very high, but so is the distance
that the current jumps -- close to an inch in some cases. Even at
smaller voltage you can get arcing if your gap is small enough.
The minimum sparking voltage for air is I believe 327 volts, so it
should not be a problem if it is 5 volts like you say. But if the
voltage is above that, then the air pressure and distance of
the gap
come into play. The lower the pressure, the bigger the gap that the
current will jump, according to Paschen's Law.
Anyway don't get me wrong, I am not against stock engines. In
fact I
think a bone-stock engine is a very good way to go for an airplane
of modest performance. The automakers have made great strides
in the
reliability of engine computers and sensors. Most of today's
better-built cars will wear out long before they have an
ECU-related
breakdown.
In fact, when it comes to adapting these engines for use in
homebuilt airplanes, the problems usually occur with the stuff
that
we add or modify -- like reduction drives, exhaust systems,
fuel and
charging systems, etc.
I really think that an airplane designed to take a box-stock RX8
engine and run it as is without any kind of modification or
add-ons,
would be an excellent idea. In fact, I am designing such a
plane and
intend to build and fly it. I will have some preliminary 3D
drawings
on my ductedfanaircraft group on Yahoo in a few days.
It is a twin-boom design, like a Cessna 336 or Adam A-500, with the
engine and duct in the back of the fuselage "stub." It will require
no reduction drive or any add-ons whatsoever. Even the stock
exhuast
system can be used as it is pointing the right way (aft).
The propulsive efficiency will be very close to that of a propeller
plane, but the big advantage is you can just take a box-stock RX-8
engine, bolt it in and fly. However, I am limiting this plane to
12,000 feet, above which you need oxygen anyway (to be legal).
But when we start talking about turbocharged planes and flying at
high altitudes, it means re-engineering a lot of the supporting
systems on the engine. At that point, it makes more sense to me to
go with mechanical systems for fuel and ignition.
Regards,
Gordon.
A few issues...
I believe that 327V applies to a 0.1" air gap. It would make sense that
smaller gaps can be jumped by lower voltage.
You can go to 14k' MSL without O2 here in the US.. I've actually been
that high to get some relief from turbulence while crossing a pass on a
windy day. Above 12.5k' MSL for more than thirty minutes requires O2.
I wouldn't own an airplane that had any sort of equipment driven
altitude restriction..
As has been discussed here before, automotive emissions laws force the
computer to run at stoichiometric mixture. Significantly better BSFC
numbers can be achieved by leaning. If you run a stock computer the
utility/economy of the plane can be improved if you come up with a way
to fool the computer. You might think that the amount of time at
partial throttle is limited, but I can think of a couple of scenarios
where part power is used for long periods - westbound x-country is often
flown at low altitude to minimize the impact of strong westerly winds..
It would be relatively easy to test the function and reliability of an
engine management computer at a simulated worst case altitude - in a
depressurized (and instrumented) chamber.
Matt-
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.