I don't think that is true Gordon. Try a 12 volt battery. Short it out and then open
the short. It will spark in air.
The Wright brothers used a set of cam driven contacts located in the combustion
chamber. When the piston got near TDC the contacts would close and open igniting the mixture.
In this situation the air pressure is higher creating a better insulator in theory.
However there was fuel vapor in there so that may have changed the insulating
properties. I am not saying a circuit board will not spark at high altitude.
Even at voltages as low as 5 volts. I am also not saying magnetos are not
pressurized for high altitude use. They are.
Most PC boards have .025 inches between the traces. Some have .01 inches between
the traces. However when the board is coated with a conformal coating, typical
for engine computers, there is no air between the traces.
Paul Lamar
Paul,
Sparks at open and close of a switch are caused by momentum due to
high load. Same with shorting out a 12v car battery. The spark will
not happen unless the connection is intermittent and current is
allowed to flow.
A PC board has no current flow between traces. You are comparing
apples and oranges.
Blake
--
Blake C. Lewis
"Sparks at open and close of a switch are caused by momentum due to
high load." That is interesting. Do you have an Internet references for that?
I thought it was the .0000001 space between the contacts that caused
the problem. Something to do with ionized air or some such.
They may not have any current flow but they do have a voltage difference.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.