Subject: OEM engine computer (Stock Engines in Homebuilt Planes
From: Rotary Engine
Date: 5/4/2007, 5:45 PM
To: AARotary Engine



Yes, coils (inductors) can make high voltage sparks from very low voltages.
Inductors do everything they can do to keep current flowing through them,
and if current is suddenly interrupted, as the magnetic field collapses it
will generate a high voltage spike.

In words, the voltage across an inductor equals the value of inductance
mulitplied by the time rate-of-change of the current going through it.  If
the current is not changing (i.e. it is dc), the voltage across the inductor
will be 0 volts (for a perfect inductor with no resistance, anyway).  But,
if you suddenly remove the current, via a switch opening or whatever, the
time rate of change of the current will be very high for a brief time, and
the voltage across the inductor will shoot up.  How high depends upon the
resistance of the inductor and wires and stuff, and how much current was
originally flowing, but it could be hundreds to thousands of volts. It is
common practice to place diodes across the coils of a relay to absorb the
inductive kickback.  If you don't, over time, the contacts of the switch
that supplies current to the coil may damaged.  This is also why switches
used with inductive loads should be rated for 5 to 10 times the expected
steady state current.

Conformal coating helps prevent arcing, but the coating is primarly there
for moisture protection.  I have had some circuits fail simply due to
moisture in the air.  If we bake the boards for a while (at 200F) they dry
out and things will start working, but after a few days the moisture gets
back in and they will start to fail (due to high impedance pathways) Dry
them out again, and they will work again.  So, our standard practice is to
bake our boards and then apply conformal coating within a few hours. The
coating will help prevent arcing, to an extent, but as I said, that is not
the purpose.  There are special potting compounds that are used for that.
The best way to prevent inductive kickbacks is to use voltage supression
devices (transient supression diodes, MOVs, etc.)

Hope this helps someone.  This is my first post, BTW, and I am an Electrical
Engineer, not that that means I am never wrong!

Jeff Rosson


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.