Subject: Wanted, dimension on RV7 or RV9 cowl.
From: Rotary Engine
Date: 5/6/2007, 2:27 PM
To: AARotary Engine

If anybody has a stock RV7 or RV9 cowl lying
around I need the dimension of the center of the prop shaft
hole from the side of the cowl.

Please set the cowl in a corner of a room with it pointing
straight up. Measure from the wall next to the side of the cowl
over to the center of the hole. Rotate the cowl 180 degrees and
do it again. You don't need the plywood as shown in this
3D using the rotating-it-180-degrees trick.

Please send the measurements. It has to do with
the reference point of the side thrust angle of the engine.
-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.