Subject: PDF, 11 pages - John Deere Stratified Turbo multifuel rotary - specs
From: Rotary Engine
Date: 5/8/2007, 6:10 AM
To: AARotary Engine



Hi All,

Yes, I'm new here... Thought that you might find this thing interesting.
This paper is from alternative motors symposium, held on Vancouver, CA
on 11-12 Aug. 1986.

Some of you know all about this SCORE issue, but for us others here's a
quite neat presentation.

To summarize, JD people successfully run their rotary engine with JET A..
with a cruise SFC of .38-.41 lb/HpHr / 231-240 g/KWh. They did it with a
"spark/pilot-twin-injection" setup, all this is explained on document.

Format is US legal, works on A4 printers too. If you find any problems,
please let me know.

Cheers,

Petri Flander
Engineering student
Helsinki, Finland

Thanks for the pdf file Petri. Too big to publish but here are some of
the tables and charts. I don't know why it did not go into production.
-- 
Paul Lamar ...No rotor no motor.

Petri, Paul

I and others would probably like to print out the file if you can give us a
source.

Thanks

Doug Fir

Lets try publishing the pdf. Here it is.

The BSFC results are suspect. I think RPI was unable
to duplicate these BSFC results when they tested the engine
later on. If the BSFC really was this good it should have gone into
production. Francois (Mistral) should also have been able to come
close to these results although I do not know if he (Mistral) tried
it with a turbcharger. I do know Wankel Gmbh had a turbocharged, direct
injection, spark assisted two rotor engine running but they did not claim
this low of a fuel burn (BSFC).

Paul Lamar ...No rotor no motor.

Paul, Petri

Thanks for sending this PDF.   Interesting layout of the engine combustion
chamber tilted over at bit. Did you notice the mention of the phrase
turbo-compounding in Fig. 18 for the 1994 year development projection?

Of course production and tooling costs would not be for the faint of heart
to produce one of the engine series much less three.  Mazda has their old
production line completely paid off now and with a minimal investment they
can produce wider 16B housings and rotors or possible modified housings for
direct heavy fuel injection.

On the other hand J.D. and other the SCORE contractors would need major
governmental (read military contracts) to get anything into production.
Some general was not very not impressed enough with the technology at the
time.  It wouldn't be the first time a valid idea got trashed.  It will
surface again no doubt.  Perhaps in India or China next time.


Doug Fir


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.