Subject: Racing Beat P Port Rotor housings
From: Rotary Engine
Date: 5/8/2007, 6:03 AM
To: AARotary Engine


  Gordon ,
  I'm not going against anything Paul has said, however if I could add a
  little in saying, I asked the same sort of questions of mechanical
  engineers
  and their answer was that that most engines tolerate some overlap (can't
  remember the degrees exactly). So the overlap of the RX7 is in line with
  this tolerance. I can't imagine the P-port being any worse in the RX8,
  although I haven't sat down and tried to work it out in degrees. We are
  speaking here primarily about idle as the higher RPM eliminates
  contamination, as the exhaust is self evacuating at the higher exhaust
  speed/RPM. In fact it's more likely to suck in some inlet charge at
  higher
  RPM.
  George (down under)

  George,

  Yes, I believe an overlap between exhaust close and intake open can
  indeed promote cylinder filling.

  In fact I have heard racing types say that the suction effect of the
  exhaust can be several times more powerful than the relatively weak
  suction effect of the piston moving down the cylinder.

  The key appears to be tuning the length of the exhaust pipes to take
  advantage of the negative pressure wave, which is reflected back up
  the pipe (toward the cylinder) at the point where there is a
  discontinuity in the pipe, such as at the exhaust collector.

  This negative pressure wave can be so strong in racing engines with
  lots of valvle overalp and tuned headers, that it is said to
  actually produces something of a supercharging effect by
  accelerating the incoming charge.

  I would imagine that the rotary could be tuned in the same manner,
  but I don't think this is needed in an aircraft engine. And
  obviously the idle quality would suffer.

  It's interesting that the Renesis has zero overlap and yet makes
  very good power. Anyway, I think it's pure speculation how a
  p-ported Renesis engine is going to perform. But I think it would
  certainly be a worthwhile project to experiment with.

  Regards,

  Gordon.

Gordon,
My  speculation is that the zero overlap arrange came from Mazda's
experiments with hydrogen fuel. The rotary is excellent (for hydrogen)
with zero overlap. They did a functional show/test car running on hydrogen.
Bill Jepson

Bill,
Very interesting - why is it so with Hydrogen?
BTW I'm back from my sojourn to Western Australia through the center of
Australia. 18,000 k's on the 1800 Suzuki, no problem with the bike. Went
through swollen rivers and all, but the whether was against me all the way,
hoping to do it by plane next time as I'm getting too old for those hard
yards.
George ( down under)


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.