Subject: Racing Beat P Port Rotor housings
From: Rotary Engine
Date: 5/8/2007, 6:03 AM
To: AARotary Engine


The problem with tig welding on the aluminum side is the welder does
not have 360 degree access to the weld line.

Paul Lamar

Paul,
I can't quite understand that one, I am trying to mentally visualize the
process and can only see a problem on the rotor side ( inside rotor housing)
and the small tig handle should enable sufficient access.
I have seen them welded from the outside and that's fine but can't remember
what they did on the inside.
George ( down under)

It is down inside the water jacket that is the problem with the tig torch.
Inside the rotor housing chamber there is no problem for the tig torch.

-- 
Paul Lamar ...No rotor no motor.


OK I got you now Paul,
I hadn't considered trying to weld inside the water jacket - I hadn't
thought it necessary. Are you concerned about corrosion of the mating
materials?
George ( down under)

The purpose of the SS tube to steel liner tig weld is to seal that area.
No because once the water jacket is potted no moisture or air can get in there.


Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.