Subject: p-port intake flange combo
From: Rotary Engine
Date: 5/8/2007, 9:55 AM
To: AARotary Engine


Have we tried this???
the hole on the bottom of the flange in RED would be where the stud is protruding from the housing. If that will work I don't know.
I don't know the exact DIMS on the ports.
But the flange is correct

Tony

Here are the exact dimensions. You must remove that stud.
-- 
Paul Lamar ...No rotor no motor.

1) Why ?

2) What is the O.D. of the port tube?
 and does it have to be that big?

3) Is there any way to drill the port without removing the flange stud? (can we get close)
to but not actually remove it?

I think if we are smart  we can incoporate the slide throttle and the flange as all one unit.
That will hold the ports in the housing in a very elegant
way.

Tony

1) It gets in the way of the hole.
2) two inches.
3) No! Put two nuts on it and back it out :)

Yes but it won't seal them. Holding it in is not the problem.
If you can seal the tube in with JB Weld it will take a ton of force to get
the tube out.
-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.