Mark,

    If it is possible, I would suggest mounting it to the non-engine
    side of the
    rubber on the S-beam. Someone reported things fatiguing when mounted
    on the
    engine side and after moving the mounting to the non-engine side the
    fatigue
    went away.

    No personal experience, just passing on what I heard. Seems to make
    sense
    though.

    Doc Custer
    Retired Software Engineer and sometime Audiologist



So, Doc, your suggestion would be to place an AL angle  which spans from
beneath each lord bushing, and then hang the intake from that angle?

Mark

Something like that. I haven't thought it through or tried a 3D of it. I
just wanted to give you a heads up on the potential vibration problem that
was reported.

Doc Custer
Retired Software Engineer and sometime Audiologist

What you need is a few of these things.
Not a good idea to drill holes in the schertz
beam but a clamp around the beam should work.
I would use a couple of the 1/4 inch 8 pound versions.

Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.